The evaporate cooling towers essentially combines a cooling tower and a
condenser coil in single equipment. It eliminates the sensible heat
transfer step of the condenser coil water which is required in the cooling
tower/condenser system. This permits a condensing temperature
substantially closer to design wet-bulb temperature, and consequently,
minimum heat process energy input.
The closed circuit cooling tower was being tested at our factory with real
heat load, with required water flow and was exported to Iraq after
confirming the performance.
The fan system sucks air through the falling water and over the coil
surface. A small quantity of the water is evaporated, removing heat from
the primary circuit and cooling it inside the coil. Therefore, like the cooling tower, all of the heat rejection is by evaporation, thus saving about 95% of
the water normally required by a "once-through" system.
